|
|
Post by Daniel F6FLU on Feb 25, 2023 9:59:57 GMT
hello,
the 1 QSO system no longer works here even if I do not select the "1 QSO" button JTDX stops as soon as I have made a QSO,
normally it should follow directly with a CQ...
I use the 160-RC3 version
I tried in AutoSeq 2 or autoseq3 but it's the same
If you had some advice...
THANKS & 73
|
|
|
|
Post by Wolfgang OE1MWW on Feb 25, 2023 11:51:10 GMT
Daniel,
if I have set '1 QSO' and finish my QSO, it will be written in the log.
In the next cyle JTDX is at 'TX6' and in the field is 'CQ OE1MWW JN88EG'
But there is no automatic transmission. JTDX is idle and decodes on the left window.
To start transmission I have to click 'Enable TX'. Please explain what you expect now ?
Uninstall/reinstall does not much do in JTDX, JTDX.ini will stay.
Therefore, to start with a 'clean' JTDX setup, make screen shots of your settings.
Radio, Audio and maybe your 'Reporting' and 'Notifications' too.
Terminate JTDX and delete the JTDX.ini and start JTDX again.
Now you have to run through all settings again. Use the screen shots as a guide.
Such a 'cleanup' is all the time a good start in case one has doubts about sequence etc.
73s, Wolfgang
|
|
|
|
Post by Arvo ES1JA on Feb 25, 2023 12:34:10 GMT
CQ is transmitted after finishing QSO only if :
1. You manually logged qso ( not automatically) and done it B4 tx cycle starts.
2. You not enabled 1 QSO button.
In other cases You need to Enable Tx again.
All this means,any QSO should have a operator move ( at least log qso), otherwise it is QSO robot and I will never let this happen in JTDX.
|
|
|
|
Post by Daniel F6FLU on Feb 25, 2023 12:41:34 GMT
Good morning
thank you for your reply
Arvo: OK that was my problem, now I'm using automatic QSO recording and that's "my" problem
whereas before I used the manual recording well
Thank you Arno I understand now for I have this problem ...
73
|
|
