|
|
Post by Jamie-K6NGN on Mar 5, 2023 18:03:20 GMT
Hi, I have downloaded the new 2.2.159 and am noticing that when I Enable-TX, it will try 2 times then stop. I never encountered this before with earlier versions. I must have a setting wrong somewhere but have had no success.
|
|
|
|
Post by Wolfgang OE1MWW on Mar 5, 2023 18:46:19 GMT
Jamie,
I guess, it's RF, that creeps into your cabling.
I own a Kenwood and an IC-705. Both are connected to my PC via USB.
If I TX with the Kenwood, I have to disconnect the 2m/70cm antenna
cable of the IC-705, otherwise all strange things will happen during
my FT8 TX cycles on the Kenwood.
There are no known bugs like the one you report, the user base of
JTDX is very big - so, check your cabling, use some Ferrite clamps.
If you want to make sure, screen shots of your JTDX setting, stop
(terminate) JTDX, delete the JDX.ini and start JTDX with a fresh
setup. Btw., a uninstall does NOT delete the JTDX.ini file.
73's de OE1MWW
Wolfgang
|
|
|
|
Post by Arvo ES1JA on Mar 5, 2023 19:18:47 GMT
Enable debug messages to All file and then when JTDX Enable Tx goes off, go and look from All file why Tx was disabled.
|
|
