|
Post by John GM0NYD on Jul 24, 2023 18:59:46 GMT
Hi all,
I am relatively new to FT8 and loving it, I downloaded the program and installed on my windows lap trop, all went well and it would auto sequence without a problem.
I now have to click on Enable TX to get the program going, which it does without a problem, it all works fine until the end of the QSO, a hand shake made then Enable TX goes out until I click on Enable TX again to get another contact then after the handshake Enable TX goes out.
Please can someone shed their thoughts on my setup.
Many thanks in advance.
John GM0NYD
|
|
|
Post by Wolfgang OE1MWW on Jul 25, 2023 5:33:26 GMT
John, this behavior is exactly as it is 'by design'. Otherwise your JTDX would become a 'robot'- at the end of your QSO it would call again CQ and so on... In fact, it is not only 'Enable TX', it is 'TX at the next cycle', either with the station info you try to contact, or it will call 'CQ'.
Tip: move your mouse slowly over the buttons or entry fields - a pop up will come up and give you more infos.
|
|