|
Post by xv9bpo on Sept 6, 2023 16:27:06 GMT
Hi all,
I do not find why with JTDX I have enable tx which turns grey in the middle of the QSO before sending my 73. It does this almost every QSO and I cannot find where in the config I made a mistake.
Any help would be much appreciated.
Thanks Greg
|
|
|
Post by Wolfgang OE1MWW on Sept 6, 2023 18:10:39 GMT
Greg, There is no config setting that would make that happen. when does that happen - if you are transmit or in a receive cycle ?
Worst case, delete or rename JTDX.ini file and start JTDX again and enter all your settings.
Maybe stray RF comes into your cabling - use Ferrite clamps over the cables.
|
|
|
Post by Arvo ES1JA on Sept 7, 2023 5:36:16 GMT
Hound mode enabled??
|
|
|
Post by xv9bpo on Sept 7, 2023 16:18:50 GMT
It happens when I send my report to a caller and the station calling me did not answer me with his report it does remove enable TX It is not related to RF I have ferrite everywhere and it does it even with 5 watts. Ok will try to delete jtdx.ini
|
|
|
Post by Arvo ES1JA on Sept 7, 2023 17:50:53 GMT
Was he continue calling You or someone else? If he was calling someone else then You should have Locked Tx=Rx, set Tx/Rx Split.
|
|
|
Post by xv9bpo on Sept 8, 2023 15:06:11 GMT
Tried everything but impossible to make it work. Came back to previous version of JTDX and no issues it is all working as expected.
I was using the 32 bits version by the way and now the 16 bits version dunno if that changed anything as anyway i went down from 159 version to 158
|
|
|
Post by xv9bpo on Oct 8, 2023 14:50:38 GMT
Actually problem came back again. Will have to do a fresh install again I believe.
|
|
|
Post by Wolfgang OE1MWW on Oct 8, 2023 16:24:21 GMT
Actually problem came back again. Will have to do a fresh install again I believe. A long existing misunderstanding - 'fresh install' - it will do NOTHING.
There is a JTDX.ini with all the settings, if it exist, it will be used again. So is in this directory the .adi file with your logs and other required files.
Uninstall does not remove/delete the JTDX.ini. Files into your install directory are just copied, no extra DLL in Windows directory, etc.
If you want a 'fresh install' - terminate JTDX, delete or rename the JTDX.ini and start JTDX again. Now you have to enter all settings again.
|
|