Post by Ramon, PE1OUW on Feb 10, 2022 18:45:13 GMT
Hello all,
I just joined the group and not sure if this has already been mentioned, but I happen to experience a sort of 'hick-up' when I use JTDX in combination with my TS-590SG. After a second or so into TX the ALC kicks in and the power is briefly reduced. It is OK again after 1 or 2 seconds. But this phenomenon is audible so it might have its effect in getting my signals out. It only happens with my Kenwood (other rigs: Yaesu FT-991A and QRPLabs QDX) which does not show this behaviour with other software (like WSJT-X and JS8Call). The power output makes no difference - it happens at 100 Watts as well as at 5 Watts. My default power is approx. 25 Watts.
Has anyone experienced the same and, if so, what can be done to remediate this?
Thanks for any advice, remediation, tips or whatever might be of help.
73,
Ramon, PE1OUW
I just joined the group and not sure if this has already been mentioned, but I happen to experience a sort of 'hick-up' when I use JTDX in combination with my TS-590SG. After a second or so into TX the ALC kicks in and the power is briefly reduced. It is OK again after 1 or 2 seconds. But this phenomenon is audible so it might have its effect in getting my signals out. It only happens with my Kenwood (other rigs: Yaesu FT-991A and QRPLabs QDX) which does not show this behaviour with other software (like WSJT-X and JS8Call). The power output makes no difference - it happens at 100 Watts as well as at 5 Watts. My default power is approx. 25 Watts.
Has anyone experienced the same and, if so, what can be done to remediate this?
Thanks for any advice, remediation, tips or whatever might be of help.
73,
Ramon, PE1OUW
