Post by wa8kqf Ron on Feb 28, 2022 20:10:18 GMT
When completing a contact (v2.2.0-rc155) I have been having a problem. I do not want to run a CQ on the frequency for the contact as the other station may want to, so I generally shift down to the area of 500 or so and find an empty slot on the waterfall. I click and show the green and red indicators there. I then click on the Enable tx Fnd my tx/rx immediately shifts back to the frequency of the previous contact.
I reset back to the 500 area, click Enable tx and my tx/rx again shifts back to the previous contact.
Why does this happen and have I set some option incorrectly to cause this?
Any information would be appreciated.
Ron
WA8KQf
I reset back to the 500 area, click Enable tx and my tx/rx again shifts back to the previous contact.
Why does this happen and have I set some option incorrectly to cause this?
Any information would be appreciated.
Ron
WA8KQf
