Post by Dave k4em on Mar 31, 2022 14:51:33 GMT
I'm using JTDX ver 2.2.159 & Thetis ver. 21k9. Thetis only has a small subset of TCI version 1.7 installed. The next release of Thetis should have more commands implemented.
I setup Thetis to use TCI with Log4OM & JTDX. I've been using it for 2 weeks now and logged several hundred QSO's without any issues. I tried F/H mode for the first time and JTDX would not work. The issue is, when I transmit, the rig (Anan 7000 DLE II) goes into transmit for 1 sec and stops, the vfo changes frequency in this case 24.910.500 and remains there.
I tried several SPLIT buttons in JTDX, restarted all programs, still the same issue.
I switched back to Virtual serial port cat control and all is OK with F/H mode.
I assume the issue is with Thetis since it does not have all commands implemented yet. Just not sure.
Is anyone having this issue?
Dave
k4em
I setup Thetis to use TCI with Log4OM & JTDX. I've been using it for 2 weeks now and logged several hundred QSO's without any issues. I tried F/H mode for the first time and JTDX would not work. The issue is, when I transmit, the rig (Anan 7000 DLE II) goes into transmit for 1 sec and stops, the vfo changes frequency in this case 24.910.500 and remains there.
I tried several SPLIT buttons in JTDX, restarted all programs, still the same issue.
I switched back to Virtual serial port cat control and all is OK with F/H mode.
I assume the issue is with Thetis since it does not have all commands implemented yet. Just not sure.
Is anyone having this issue?
Dave
k4em
